Product list of Flexiglass Challenge Industries (NZ) Ltd is Car Canopies. Category of Flexiglass Challenge Industries (NZ) Ltd is a Automotive: Accessories. In total the company used 1 trading name. Flexiglass Challenge Industries (NZ) Ltd was registered for the GST on.
The previous headquarters were located in 340 Neilson St Penrose Auckland. Since, the company is headquartered in New Zealand. Its New Zealand Business Number is 824905395. This firm was registered on and was issued with the 594824218 NZCN. Repeat for all other actuators.See also such companies as Flexiglass Challenge Industries (NZ) Ltd: Amuri Helicopters | Brida Investments | Coromandel Cacti | Hynds Pipe Systems Ltd | Pink Bins Company Ltdįlexiglass Challenge Industries (NZ) Ltd is New Zealand proprietary company. Drill one hole at each end of the bracket with a 4.5mm drill, then screw the bracket onto the window frame using the 8g x 12 screws supplied making sure that the bracket does not interfere with the movement of the handle.
Hold a protection bracket over the top of an actuator and mark the position for holes to be drilled through the bracket. If the pins are not traveling in the same direction then reverse the connections to each actuator that is travelling in the opposite direction.
Operate remote controller and make sure all actuator pins travel in the same direction at the same time and when the lock button is pressed all the pins are in the locked position. Connect all actuators to cabling using female bullet connectors and then connect power to controller. Make sure the duct does not interfere with the movement of the pin of the actuators, however loom tube could be used instead of the plastic duct. We found it easiest to run cables in loom tube to inside the canopy and then run a piece of 25 x 16 plastic electrical duct under the window frame from front to rear on each side of the canopy holding it in place with double sided tape and some dobs of silicone. Referring to the wiring diagram, run a 15amp cable to the controller from a positive power source and connect the black wire to a negative, then run 2 wires (3mm 10amp) from the controller white & white/black to the first actuator and then loop wires to all other actuators. Mount controller anywhere in cabin (this is important for ease of accessibility in the event of unforeseen failure). Repeat step 1 & 2 for all 6 window handles. The bracket can also be bent up or down to ensure the actuator pin engages with the pin when locked and clears the bracket when unlocked. This can be done by using a file to make the hole larger. Note: The hole in the bracket may have to be enlarged to ensure that the pin moves freely with the window handle in the open or closed position. Secure actuator to window frame using the 2 of the 8g x 12 screws. Now push the pin of the actuator fully down to make sure that the top of the pin clears the bracket so the window can be opened. Where the bracket is now installed place an actuator on the inside of the window frame under the bracket with the actuator pin extended upwards and line up the pin to the center of the hole in the bracket and the shoulder on the pin to the underside of the bracket. FLEXIGLASS CANOPIES NZ INSTALL
Using the pop rivets supplied install the bracket onto the top of the window frame with the bent edge facing up. Drill two holes through the bracket and into the window frame with a 3.5mm pop rivet drill.
Select location for bracket (close to handle but leave enough room so as not to interfere with movement of handle, and making allowance for the protection bracket to be installed). Installation:(Note if you are unsure of these steps please refer to the picture gallery at - most steps are shown)
0 kommentar(er)
